Installation Guide

INSTALLATION
Tools:
Adjustable Wrench Power Drill Teon Tape Rags
Model Number: 2AM600, 2MT600
Warnings and Notes:
Check with local plumbing code requirements before installation.
This product should be installed by a local listed plumber.
Do not use plumbers putty on threads.
Installation Steps:
Wallmount Pot Filler
32mm
[1 1/4"]
1/2" IPS
Finish Wall
13mm
[ 1/2"]
(1) Conrm the 1/2” IPS/NPT threaded inlet
pipe nipple must be kept with a length of 1/2”
from the nished wall.
PIONEER INDUSTRIES, INC.
3325 S. Gareld Ave
Commerce, CA 90040
[phone]
www.pioneerind.com
(7) Carefully screw the pot-ller into inlet pipe
nipple using adjustable wrench to fully tighten
the pot ller. Ensure the notches on the faucet
align with the 3/32” Allen screw.Level the pot
ller. Tighten the 3/32” Allen screw.
(2) After wall is nished install the pot ller to
the 1/2” IPS/NPT threaded inlet pipe nipple.
Do not fully tighten.
(3) Level the pot-ller. Mark the drilling hole
location on the nished wall. Space remove
the pot ller.
2.4mm
[3/32"]
(4) Drill the four 3/32” holes on the premarked
location
(6) Remove the 3/32” Allen screw
(5) Apply Teon tape to thread end of inlet
pipe nipple before installing the mounting
bracket. Put the mounting washer on the
wall and drill the 3/32” hole on the same
location as wall. Ensure the mounting washer
is behind the mounting bracket to form the
watertight seal. Install the mounting bracket
with the mounting screws supplied with faucet.
Tighten the mounting screws.
(8) Place the escutcheon in correct position.
Tighten the 1/16” Allen screw
(9) Make sure the pot ller spout swivels
smoothly. Place a bucket underneath of the
pot-ller. Remove the aerator.
(10) Turn on inlet water supply. Make sure
all the connections are secure. Open both
handles. Flush and allow water to run at full
ow for at least one minute. Turn off water and
replace the aerator.