Installation Guide

INSTALLATION
Tools:
Adjustable Wrench Teon Tape Rags
Model Number: 2MT700, 2AM700
Warnings and Notes:
Check with local plumbing code requirements before installation.
This product should be installed by a local listed plumber.
Do not use plumbers putty on threads.
Installation Steps:
Deck Mount Pot-Filler
(1) Shut off water supply. Remove old faucet.
Clean mounting surface in preparation for new
faucet.
PIONEER INDUSTRIES, INC.
3325 S. Gareld Ave
Commerce, CA 90040
[phone]
www.pioneerind.com
(2) Do not remove plastic arm bracket before
nish installation to prevent damage on swivel
arms. Be sure to place gasket underneath of
faucet to form watertight seal.
(3) Guide the faucet through mounting hole.
Slide the washer from beneath the mounting
surface. Install the locknut with the help of
mounting tool
(4) Use faucet inlet supply hose to connect
to supply stop. You may need adapter(not
included) if supply stop outlet size is not 3/8”
compression.
(6) Remove the aerator from the spout by
turning counter-clockwise. Turn on supply
stop. Check of any leaks. Make sure all the
connection are secure. Open both handles.
Flush and allow water to run at full ow for at
least one minute. Turn off water. Replace the
aerator.