Installation Guide

Model Number: 3MO200
Warnings and Notes:
Check with local plumbing code requirements before installation.
This product should be installed by a local listed plumber.
Do not use plumbers putty on threads.
Installation Steps:
Two Handle Lavatory Widespread Faucet
(1) Shut off water supplies. Remove old faucet.
Clean mounting surface in preparation for new
faucet.
(2) Place spout ange under the spout.
Ensure there is a washer under the spout
ange. Place the spout in position on the sink.
From under the sink slide mounting bracket
through spout shank. Thread nut onto spout
shank properly and tighten nut.
(3) Thread Y connector to the spout shank.
Ensure there is a washer in the Y connector.
Do not overtighten.
(4) Place hot and cold side valve in posi-
tion on the sink. From under the sink place
washers and thread locknut with the help of
1-11/32” size socket.
(5) Connect both hot and cold side valve
outlet hose to Y connector.
(6) Install the inlet hoses to the main supply
stops. Turn on supply stops. Check for any
leaks. Make sure all the connections are
secure. Remove aerator. Turn on both hot
and cold water and let water run at least
one minute. Then turn off water and replace
aerator.
Pop-up Drain Installation:
PIONEER INDUSTRIES, INC.
3325 S. Gareld Ave.
Commerce, CA 90040
[phone]
www.pioneerind.com
INSTALLATION
Tools:
Adjustable Wrench Plumbers Putty Teon Tape Rags
(1) Remove pop-up ange from body
(2) Place a ring of putty on the bottom of
ange.
(3) Insert pop-up ange through drain hole
and attach fIange to body. Ensure the pop-up
outlet faces towards the back of the slnk
Tíghten the locknut securely with a wrench Do
not overtighten.
(4) Remove the excess putty. Connect the
trap (check manufacturer’s instructions for
ínstallation)