Engineering Excellence Engineering E xcellence Installation Guide Single Handle Wallmount Roman Tub Set: • 4MT840 This product meets the following standards: • • • ASME A112.18.1 ANSI A117.1 CUPC / IAPMO LISTED / ADA COMPLIANT Pioneer Industries, Inc.
Thank you for purchasing this pioneer quality product. Tools Required Adjustable Wrench Teflon Tape Rags 3/32” Allen Wrench Prior to Installation • Observe all local plumbing and building codes before you begin installation. • Carefully shut off both hot and cold water supplies. • Plug the tub drain with a soft cloth to prevent intrusion of debris or the loss of any parts. • Pioneer reserves the right to make changes in the design of faucets without notice.
Valve Installation • • • • • • Note:- The wall bracket (A) requires special framing and support considerations. Please pay special attention to minimum and maximum dimension recommendations noted. Refer to the specification for additional dimension information. A suggested framing example is shown. Each installation may have different framing requirements than shown. Construct the framing for your installation.
Valve Installation • • • • • • • Attach the valve body (E) to the wall bracket (A) with the screws (D) and washers (C) provided. Tighten the screws (D) securely Before soldering remove all the components (like retainer sleeve (N), ceramic cartridge (O), retainer nut (P) and retainer ring (Q)) to prevent internal damage. Solder the 1/2” hot and cold water supply lines to the valve. After soldering replace all the components removed. Position a bucket in front of the spout shank.
Trim Installation • • • • • Note:- To make sure proper fit and appereance, do not oversize the spout and handle shank holes. Complete the finished wall with one 1-1/2” hole for spout and one 2” hole for valve. Both holes should be 4” center apart. Remove the guards (J) once the finished wall is complete. Place the spout escutcheon (L) with the rubber washer underneath to the spout shank (K). Thread spout (M) on the spout shank (K). till against the finished wall. Make sure the spout (M) faces downword.
To Set or Adjust Temperature Limit Stop Caution: Valve is preset at the factory test at maximum. Adjust as necessary. Please see the instructions below: • • • • • • Turn off water and relieve the pressure. Remove handle by removing button and loosening allen screw lift off handle. Counterclockwice unscrew retainer ring (U) and retainer nut (T) counterclockwise. Use two fingers to raise the red adjustment ring (V).
Engineering Excellence Engineering E xcellence 3325 S. Garfield Ave. | Commerce, CA 90040 Telephone: (800) 338-9468 | (323) 888-8873 | Fax: (323) 888-9515 Hours: M - F, 7:30am to 5:00pm PST www.pioneerind.