Use and Care Guide

ManualsBrandsPioneer Industries ManualsKitchen Faucets2DM201

Engineering Excellence

Installation Guide

Two Handle Kitchen Faucet:

2DM200•

2DM201•

This product meets the following standards:

ASME A112.18.1 •

ANSI A117.1 •

ANSI / NSF 61, SECTION 9 •

CUPC / IAPMO LISTED / ADA COMPLIANT•

CONTAINS NO MORE THAN 0.25% WEIGHTED AVERAGE LEAD •

CONTENT

Summary of content (6 pages)

PAGE 1
Engineering Excellence Installation Guide Two Handle Kitchen Faucet: • 2DM200 • 2DM201 This product meets the following standards: • ASME A112.18.1 • ANSI A117.1 • ANSI / NSF 61, SECTION 9 • CUPC / IAPMO LISTED / ADA COMPLIANT • CONTAINS NO MORE THAN 0.25% WEIGHTED AVERAGE LEAD CONTENT Pioneer Industries, Inc.
PAGE 2
Thank you for purchasing this Pioneer quality product. Tools Required Plumbers Putty Sealant Tape 3/32” Allen Wrench Flex Hose Rags AdjustableWrench Prior to Installation • • • • • Observe all local plumbing and building codes before you begin installation. Carefully shut off both hot and cold water supplies from under the sink. Plug the sink drain with a soft cloth to prevent intrusion of debris or the loss of any faucet parts.
PAGE 3
Faucet Installation • 1. 2. 3. 4. 5. 6. 7. Note: The faucet escutcheon (F) is supplied with gasket (G) to form watertight seal. Do not use gasket (G) and plumbers putty both to form watertight seal. For the faucet with side spray, place the hose guide (A) through the sink hole. Apply adequate amount of plumbers putty or sealant along the boundary of the side spray flange (B). Hand tighten the locknut (C) from underneath the sink. Remove excess plumbers putty or sealant from the side spray flange (B).
PAGE 4
Faucet Installation • Note: The faucet escutcheon (L) is supplied with gasket (M) to form watertight seal. Do not use gasket (M) and plumbers putty both to form watertight seal. 8. Place the escutcheon (L) from the top. Ensure the gasket (M) is beneath the escutcheon (L). The hot side valve should have red mark and the cold side should not have any mark. Place the cold side valve with washers (N & O) and locknut (P) from under the sink. Thread the escutcheon (L) on the valve.
PAGE 5
Main Supply Connection 12. Connect the valves to inlet supply lines (R). Connect the supply stops (Q) to the inlet supply lines (R) (left is hot water supply and right is cold water supply). Make sure inlet supply lines (R) are securely tighten. Do not overtighten. Turn on water. 13. Remove aerator (S). 14. Open the handles. 15. Check for any leaks. Make sure all the connection are secure. 16. Flush and allow water to run at full flow for at least one minute. 17. Close the handles. 18. Replace aerator (S).
PAGE 6
Engineering Excellence 3325 S.