Installation Guide

REV-12 2, 13

Trim Installation

Turn off the main water supply1.

Removetestcap(G)withthehelpof1-11/32”socket,relivethewater2.

pssureensureallthedebrisareushedoutofthesystem.

Threadsleeve(H)tothevalvebody.Insertthecartridge(I)tothevalve3.

body.EnsuretoinstallCartridgeunitsocoldwaterowsrst.Ensure

the two notches underneath of the cartridge seats properly in the valve

body.Holdthecartridge(I)andthreadthelocknut(J)tosleeve(H).

Threadretainercap(K)toretainernut(J).

For back to back installation:- Rotate the cartridge 180 Degree. Ensure 4.

‘B-BUP’symbolonthecartridgeisonthetop.Followtheinstructionon

3toinstallsleeve(H),locknut(J)andretainercap(K).

Turnonthemainwatersupply.Checkforanyleak.Turnthecartridge(I)5.

counterclockwise to the full open position. Allow water to run for some

time until the hot water comes out. Check the temperature with ther-

mometer for the hot water.

If necessary to reduce the hot water temperature then, turn off main 6.

watersupply.Removethecartridgebyremovingretainercap(K)

andlcoknut(J).Turnredtemperatureadjustingring(L)clockwiseto

decrease the temperature. Follow instruction 3 or 4 to reassemble the

cartridge(I).Ensurethehotwatertemperatureissetbelow120°F.