User Manual

25
Section
04
English
En
Installation
• To prevent a short-circuit, overheating
or malfunction, be sure to follow the
directions below.
— Disconnect the negative terminal of
the battery before installation.
— Secure the wiring with cable clamps
or adhesive tape. Wrap adhesive
tape around wiring that comes into
contact with metal parts to protect the
wiring.
— Place all cables away from moving
parts, such as the gear shift and seat
rails.
— Place a ll cables away from hot
places, such as near the heater
outlet.
— Do not connect the yellow cable to
the battery by passing it through the
hole to the engine compartment.
— Cover a n y di s c o n n e c t e d ca b l e
connectors with insulating tape.
— Do not shorten any cables.
— Never cut the insulation of the power
cable of this unit in order to share the
power with other devices. The current
capacity of the cable is limited.
— Use a fuse of the rating prescribed.
— Never wire the negative speaker
cable directly to ground.
— Never band together negative cables
of multiple speakers.
• When this unit is on, control signals
are sent through the blue/white cable.
Connect this cable to the system remote
control of an external power amp or the
vehicle’s auto-antenna relay control
terminal (max. 300 mA 12 V DC).
If the vehicle is equipped with a glass
antenna, connect it to the antenna
booster power supply terminal.
• Never connect the blue/white cable to
the power terminal of an external power
amp.
Also, never connect it to the power
terminal of the auto antenna. Doing
so may result in battery drain or a
malfunction.