Operation Manual

Using the USB DAC function 05
13
En
English
DeutschFrançais
Nederlands
Italiano Español Русский
Chapter 5:
Using the USB DAC function
Install the driver
• To use the DIGITAL IN USB terminal to play back
music files on the computer with the unit, you need
to install a dedicated driver on your computer. For
details, refer to the Pioneer website. The instruction
manual also contains information regarding the
installation procedure and computer settings, so
refer to the instruction manual as well.
Playing music from a computer
Use this function to play digital audio input to the unit's
rear panel DIGITAL IN USB port.
1 Connect the unit to a computer via USB
cable (page 7).
2Press
USB to select DIGITAL IN USB as
the input source.
• When using the front panel controls, rotate the
INPUT SELECTOR knob.
• Sound is produced from the LINE 2 OUT terminals.
3 Begin playback on the computer.
Note
• When the unit and a computer are connected to
play back audio with a USB cable, the unit can
input the following signals:
Linear PCM
– Quantitative bits: 16 bit, 24 bit, 32 bit
– Sampling frequency: 44.1 kHz, 48 kHz, 88.2 kHz,
96 kHz, 176.4 kHz, 192 kHz, 352.8 kHz, 384 kHz
DSD
– Sampling frequency: 2.8 MHz, 5.6 MHz, 11.2
MHz
• Playback cannot be controlled from this unit during
use of this function; use your computer to control
playback.
• When disconnecting the USB cable, always stop
playback on the computer first.
• Sound may not be produced if your computer does
not support USB 2.0 HS.
• This unit does not support use of a USB hub.
Always use a USB cable to connect the unit directly
to the computer.
A70_SYXE8_0728.book 13 ページ ２０１５年７月２８日 火曜日 午後３時５４分