Installation Instructions

4
Connecting the units
Connecting the power cord
Speaker leads
White: Front left 
White/black: Front left 
Gray: Front right 
Gray/black: Front right 
Green: Rear left  or subwoofer 
Green/black: Rear left  or subwoofer 
Violet: Rear right  or subwoofer 
Violet/black: Rear right  or subwoofer 
ISO connector
Note:
In some vehicles, the ISO connector may be divided into
two
. In this case, be sure to connect to both connectors.
(AVH-P4200DVD only)
When you connect the separately sold
multi-channel processor (DEQ-P6600) to this
unit, do not connect anything to the speaker leads
and system
remote control (blue/white).
Note:
Depending on the kind of vehicle,
the function of 2* and 4* may be
different. In this case, be sure to
connect 1* to 4* and 3* to 2*.
1*
3*
2*
4*
Y
ellow (2*)
Back-up
(or accessory)
Y
ellow (1*)
Connect to the constant 12 V
supply terminal.
Connect leads of the same
color to each other.
Fuse resistor
Red (4*)
Accessory
(or back-up)
Red (3*)
Connect to terminal controlled by
ignition switch (12 V DC).
Black (chassis ground)
Connect to a clean, paint-free metal location.
This product
(AVH-P4200DVD only)
(AVH-
P4200DVD
only)
Antenna input
Orange/white
Connect to lighting switch terminal.
Fuse resistor
4 m
Fuse (10 A)
AUX jack (3.5 ø) (AVH-P4200DVD only)
Use a mini plug cable to connect with auxiliary device.
Microphone input (AVH-3200BT only)
RGB input
Navigation unit
(AVIC-F220 (sold
separately)).
Please contact your dealer to
inquire about the connectable
navigation unit.
Insert the 26 pin cable in the direction
indicated in the figure.
26 pin cable (Supplied with Navigation unit)