DVD Player User Manual

Introduction of setup
adjustments
1
1
1
1 Setup menu display
Shows the setup function names.
1 Touch AV MENU and then touch SETUP
to display the setup function names.
The setup function names are displayed and
operable ones are highlighted.
2 Touch ESC to return to the display of
each source.
# To return to the previous display, touch
BACK.
Setting the AV input
You can switch the setting according to the
connected component.
! Select VIDEO to watch video of a con-
nected component as AV source.
! Select S-DVD to watch video of a con-
nected DVD player as S-DVD source.
% Touch AV INPUT on the setup menu to
select the AV input setting.
Touch AV INPUT until the desired setting is se-
lected.
! OFF – No video component is connected
! VIDEO – External video component (such
as portable video player)
! S-DVD – DVD player connected with RCA
cable
# When a DVD player is connected with an AV-
BUS cable, do not select S-DVD otherwise no pic-
ture will be displayed even if you select S-DVD as
a source.
About AV input
Depending on the unit connected to this unit,
video image may be distorted. In this case,
switch the video image selecting switch on
the underneath of the hide-away unit to the ap-
propriate position to eliminate distortion. Use
a thin standard tip screwdriver to switch the
video image selecting switch on the under-
neath of the hide-away unit.
Setting for rear view
camera (back up camera)
CAUTION
Pioneer recommends the use of a camera
which outputs mirror reversed images, other-
wise screen image may appear reversed.
Setup
En
109
Section
21
Setup