Owner's Manual

! Before getting out of the car to place the
markings, be sure to turn the ignition switch
off (ACC OFF).
! The range projected by the rear view camera
is limited. Also, the vehicle width and distance
guidelines displayed on the rear view camera
image may differ from the actual vehicle
width and distance. (The guidelines are
straight lines.)
! The image quality may deteriorate depending
on the usage environment, such as at night or
in dark surroundings.
1 Park your vehicle in a safe place and
apply the parking brake.
2 Using packing tape or similar, place
markings approximately 25 cm from each
side of the vehicle, and approximately
50 cm and 2 m from the rear bumper.
Rear bumper
25 cm
(9-7/8 in.)
25 cm
(9-7/8 in.)
50 cm (1 ft. 8 in.)
2 m (6 ft. 7 in.)
Markings
Markings
3 Display the “System Settings” screen.
= For details, refer to Displaying the screen for
system settings on page 144.
4 Touch [Back Camera Settings].
The “Back Camera Settings” screen appears.
5 Touch [Parking Assist Line Adjustment].
A confirmation message appears.
6 Touch [OK].
The screen for setting the guidelines appears.
7 Touch
or to select a point.
8 Touch , , or to adjust the po-
sition of the point.
p When a point is moved, the distance from
the initial value is displayed at the top right
of the screen.
9 Touch [OK].
The set value is saved and the rear view image
appears.
# If you touch [Default], the point returns to the
preadjustment position.
# If you touch
, the display returns to the set-
ting screen for guidelines without reflecting the
setting.
En
162
Chapter
27
Customizing preferences