Owner's Manual

Messages for navigation functions
The following messages may be displayed by your navigation system. Refer to the table to identify
the problem, then take the suggested corrective action.
There are occasions when you may see error messages other than those shown here. In such
cases, follow the instructions given on the display.
Message Cause Action (Reference)
Route calculation was not
possible.
Route calculation has failed be-
cause of a malfunction in the map
data, software, or hardware.
! Change the destination.
! Consult the Pioneer Local dealer if this mes-
sage persists.
Route calculation not possi-
ble. Destination too far.
The destination is too far. Set a destination closer to the starting point.
Route calculation not possi-
ble. Destination too close.
The destination is too close. Set a destination farther from the starting
point.
Route calculation not possi-
ble. Navigation cannot be pro-
vided around destination or
starting point.
The destination, waypoint(s), or
starting point are in an area where
no road exists (e.g. a mountain) and
the route calculation is impossible.
! Set a destination and waypoint(s) on roads.
! Reset the destination after you drive the ve-
hicle to any road.
Unable to find any road lead-
ing to the destination.
The destination or waypoint(s) are in
an isolated island, etc. without a
ferry and the route calculation is im-
possible. If there is no road con-
nected to your starting point or
destination, this message will ap-
pear.
Change the destination.
Failed to create route profile In rare cases, a route calculation
error may occur.
! Retry.
! Consult the Pioneer Local dealer if this mes-
sage persists.
No image file. “Pictures” folder exists on the SD
memor y card but there is no load-
able data in the folder.
Use appropriate data and store it correctly.
(Page 146)
Unsupported file format. An image file was not made to spe-
cifications as the splash screen.
Use appropriate data and store it correctly.
(Page 146)
Abnormal status on speaker
connection or main unit was
detected. If it does not return
to normal status after ACC
off/on, consult Pioneer
authorized dealer or Pioneer
service.
This unit fails to operate or the
speaker connection is incorrect; the
protective circuit is activated.
Check the speaker connection. If the mes-
sage fails to disappear even after the engine
is switched off/on, contact your dealer or an
authorized Pioneer Service Station for assis-
tance.
En
172
Appendix
Appendix