Owner's Manual

Black plate (164,1)
! When this navigation system is connected
to a power amp with an LPF (low pass fil-
ter), turn the LPF off before performing
Auto EQ. Also, set the cut-off frequency for
the built-in LPF of an active subwoofer to
the highest frequency.
! The distance has been calculated by com-
puter to provide optimum delay to ensure
accurate results. Do not change this value.
— The reflected sound within the vehicle is
strong and delays occur.
— The LPF on active subwoofers or exter-
nal amps delay the lower sounds.
! If an error occurs during measurement, a
message appears and measurement is
canceled. Check the following before mea-
suring the vehicle’s acoustics.
— Front speakers (left/right)
— Rear speakers (left/right)
— Noise
— Microphone for acoustical measure-
ment (sold separately)
— Low battery
Performing Auto EQ
p Auto EQ changes the audio settings as fol-
lows:
! “Auto EQ” on the “EQ Menu” screen is
set to “On”.
= For details, refer to Using the auto-ad-
justed equalizer on page 161.
! The fader/balance settings return to the
center position.
= For details, refer to Using balance ad-
justment on page 159.
! The equalizer curve switches to “Flat”.
= For details, refer to Using the equali-
zer on page 159.
! The front and rear speakers will automa-
tically be adjusted to a high pass filter
setting.
p Previous settings for Auto EQ will be over-
written.
p For AVIC-Z150BH users
Do not press the h button to open or close
the panel when you are using the micro-
phone.
1 Stop the vehicle in a quiet place, close
all the doors, windows and sun roof, and
then turn the engine off.
If the engine is left running, engine noise may
prevent correct Auto EQ.
p If driving restrictions are detected during
measurement, measurement is canceled.
2 Fix the microphone for acoustical mea-
surement (sold separately) in the center of
the headrest of the driver’s seat, facing for-
ward.
The Auto EQ may differ depending on where
you place the microphone. If desired, place
the microphone on the front passenger seat
and perform Auto EQ.
3 Disconnect the iPhone or smartphone
device.
4 Turn on the ignition switch (ACC ON).
If the vehicle’s air condi tioner or heater is
turned on, turn it off. Noise from the fan in the
air conditioner or heater may prevent correct
Auto EQ.
5 Switch the AV source to “Off”.
= For details of the operations, refer to Dis-
playing the AV operation screen on page 76.
6 Set the video setting for the rear dis-
play to “Mirror AV”.
= For details of the operations, refer to Select-
ing the video for rear display on page 168.
<CRB4224-A>164
En
164
Chapter
27
Customizing preferences