User manual

06
36
En
Connecting by WPS
If your mobile device supports WPS (by push-button
method), it can be connected.
1 Display the Miracast/Wi-Fi Direct mode screen.
2Use 2/1 to select WPS, then press ENTER.
3Use 2/1 to select Next, then press ENTER.
4 Within 2 minutes, turn on the mobile device’s
WPS setting.
Once the connection is completed, [ Connection Success ]
appears on the TV screen.
Note
• For instructions on operating your mobile devices,
see their respective operating instructions.
5 Press ENTER.
This completes the connection.
The Miracast/Wi-Fi Direct mode screen is displayed.
Change SSID and password
Change the SSID and password used to connect the unit
and a mobile device.
1 Press Í STANDBY/ON and the power to the unit
will come on.
The Pioneer logo will be displayed on the TV screen.
2 Press Miracast to display the Miracast/Wi-Fi
Direct mode screen.
3Use 2/1 to select Refresh, then press ENTER.
SSID and password will be changed.
The connection between the unit and mobile device will
be terminated.
Caution
• All connection settings that have been setup for
mobile devices will be removed.
• The SSID and password will not change until an
update (Refresh) is performed. You should
periodically perform an update (Refresh) for security
reasons.
After the connection is terminated, when using the unit’s
Miracast/Wi-Fi Direct function again you will also need to
set up the connection again.
BDP-X300_72-BDPX300-GBRB1_En.book 36 ページ ２０１６年５月２４日 火曜日 午後１時１０分