Manual
TO PLAY ONLY DESIRED SCENES/TRACKS- ProgramPlayback
Selected chapters (LD) or tracks (CDV/CD) can be played in
any desired order (max. 24 chapters or tracks).
Press PGM.
8
PGM
Displaywith adisc containing a TOC
• You can view the state of programming on the monitor
TV screen.
• With CDs or CDV discs, the total time of the programmed
tracks can be displayed.
2 Select the desired chapters or tracks.
With two-sided LDs, first specify side A or side B with DISC
SIDE A or B and then enter the number of the desired
chapter with the digit buttons.
Example: To program chapter 9 on side B, chapter 7 on
side A, and chapter 18 on side B, in that order:
Screen display after programming is completed
_3 0 . 12 A PLAY 1
Program
Step- 4
Programmed chapters -- I18"0"91"_-]'"B078!81 __
t
With single-sided LDs, CDs, and CDV discs, just enter the
number of the desired chapter or track with the digit buttons.
Example: To program CD tracks 9, 7, and 18 in that order:
If you make a mistake during entry:
Press CLEAR and enter the correct number with the digit
buttons.
1i3. Q- 131ZI
Screen display after programming is completed
r5 0.32 pLAy 1
Number of programmed tracks _k- -
and total play time i ;;;;I;:::
Programmed track numbers 1
Press PLAY I_.
PLAY
}
The chapters/tracks are played in the programmed order.
When all programmed chapters/tracks have been played, the
player enters stop mode.
To stop program play in the middle:
• Press • on the front panel of the player or EJECT II/A on the
remote control unit.
• Press CLEAR on the remote control unit.
To clear the program contents:
• Open the disc table.
• Press CLEAR on the remote control unit in stop mode.
Programming a pause:
tnserting a pause in your program can be very useful when carrying
out recording.
• For example, when recording on both sides of a cassette tape, if
you program a pause after the last track to be recorded in the first
side, program playback will pause at that point to allow you to
switch tape sides.
• Inserting pauses in a program will also allow you to record blank
sections on atape which are useful for music search functions, or
to record narration between selections, etc.
• To resume program playback when the unit is in pause mode,
press PAUSE It.
34
<VRB1142>
To program a pause:
In step 2 of the above procedure, press PAUSE II instead of entering
a chapter or track number.
NOTES:
• Apausecannotbeprogrammedforstep 1,norfortwoconsecutive
steps.
• A pause can be programmed for the lastprogram step, however,
it will not be effective.
Programmed pause indication:
On the monitor screen - it
tn the front panel display window - PA