Owner manual

Preset Stations
10 stations can be preset in each of the 3 classes, for a total of 30
station presets.
CLASS A: 1 to 0 CH
CLASS B: 1 to 0 CH
CLASS C; 1 to 0 CH
Preset stations to take full advantage of this tuner's basic
performance capabilities.
1. Tune in the desired station.
For details concerning tuning, refer to "BASIC TUNING
OPERATIONS" on page 8 and 9.
2. Press the MEMORY button.
• The MEMORY indicator will light for several seconds.
• Memory storage is not possible once the indicator goes off.
In this case, press the MEMORY button again.
• If the button is pressed again while the indicator is lit up, the
memory function will be canceled.
3. Select the desired class (A to C) with the CLASS
button.
4. While the MEMORY indicator is lit, press the
desired STATION CALL button.
Pressing a STATION CALL button causes the MEMORY
indicator to go out and the station to be preset.
A station is preset (memorized) a few seconds after pressing
the STATION CALL button.
5. Repeat procedure 1 to 4 to memorize other
stations.
NOTES:
• You can also store MPX MODE and RF ATT settings in memory.
9 If a station is memorized with the STATION CALL buttons at a
position where a station is already memorized, the previous
contents are erased and the new data is stored in memory.
• If preset stations get erased, repeat the preset procedure from
the beginning.
Preset Station Tuning
1. Select the class number with the CLASS button.
2. Press the STATION CALL button to select the
desired preset.
NOTES:
• The contents of preset memory will be retained for several days,
even if the tuner's power cord is unplugged.
0 If a preset station has been erased, preset it again.
10