Stereo System User Manual

Understanding built-in CD
player error messages
When problems occur during CD play an error
message may appear on the display. If an
error message appears on the display refer to
the table below to see what the problem is and
the suggested method of correcting the pro-
blem. If the error cannot be corrected, contact
your dealer or your nearest Pioneer Service
Center.
Message Cause Action
ERROR-11, 12,
17, 30
Dirty disc Clean disc.
ERROR-11, 12,
17, 30
Scratched disc Replace disc.
ERROR-10, 11,
12, 17, 30, A0
Electrical or me-
chanical
Turn the ignition
ON and OFF, or
switch to a differ-
ent source, then
back to the CD
player.
ERROR-22, 23 The CD format
cannot be played
back
Replace disc.
ERROR-44 All tracks are
skip tracks
Replace disc.
Understanding built-in MD
player error messages
When problems occur during MD play an
error message may appear on the display. If
an error message appears on the display refer
to the table below to see what the problem is
and the suggested method of correcting the
problem. If the error cannot be corrected, con-
tact your dealer or your nearest Pioneer Ser-
vice Center.
Message Cause Action
Blank MD Blank disc is in-
serted.
Replace disc.
TEMP The temperature
of this unit is out-
side of the nor-
mal operating
range
Wait until the
units temperature
returns to within
normal operating
limits.
ERROR-11, 12,
17, 30
Dirty disc Clean disc.
ERROR-11, 12,
17, 30
Scratched disc Replace disc.
ERROR-01, 11,
12, 17, 30, A0,
A1
Electrical or me-
chanical
Turn the ignition
ON and OFF, or
switch to a differ-
ent source, then
back to the MD
player.
ERROR-20, 21 Track information
cannot be read.
Reload the MD.
ERROR-20, 21,
24
There is some-
thing wrong with
the MD.
Replace disc.
ERROR-23 The MD contains
recorded infor-
mation other
than music.
Replace disc.
ERROR-A1 Electrical or me-
chanical
Press RESET.
ERROR- MD play not pos-
sible.
Replace disc, or
press RESET.
Understanding auto TA and
EQ error messages
When correct measurement of car interior
acoustic characteristics is not possible using
the auto TA and EQ, an error message may ap-
pear on the display. If an error message ap-
pears on the display refer to the table below to
see what the problem is and the suggested
method of correcting the problem. After
checking, try again.
Additional Information
En
65
English
Appendix