User guide

English

10.

Bundling the cables.

Follow the steps below to attach a cable clamp.

1 ) Thread the clamp band through the holder and

bundle the cable(s) in the cable clamp.

2 ) Push and hold the levers then insert the hook into

an appropriate hole on the rear of the ﬂat screen TV.

3 ) Pull up the clamp band to lock.

4 ) Conrm that the cable clamp is seated rmly in the

panel.

NOTE:

Avoid pinching or creating pressure points when routing

or bundling cables.

To remove the clamp band, pull and hold the latch to

release.

To remove the cable clamp, push and hold the levers

then pull it out from the hole.

Latch

Lever

NOTE:

The longer a clamp is in place, the better chance of

deterioration. An older clamp is more easily damaged

while being removed and may not be reusable.

 Rear of flat screen TV

Speaker cable

Cable clamp

When using the hung on

wall unit:

NOTE:

First lay the flat screen TV on top of a soft sheet etc., then

attach the speakers.

1. Attach the speakers to the ﬂat screen

TV (See procedures 1 to 10 on pages

3 to 6).

Connect the other cables and power cord to the at

screen TV.

2. Place the ﬂat screen TV on the

mounting ﬁttings of the hung on

wall unit.

For details, refer to the operating instructions supplied

with the hung on wall unit.

Caution

Do not move the flat screen TV by holding these speakers

or speaker brackets. This could result in injury or damage

to the brackets. When moving the TV, hold by the top and

handles.