Operation Manual

37
En
07
Chapter 7
Surround sound settings
Important
• Press SYSTEM CONTROL to set the remote control to receiver
control mode in order to operate the receiver subwoofer (make
sure that the LCD displays the SYSTEM screen, as shown
below).
Using the Sound Setup menu
From the Sound Setup menu you can access all the surround sound
settings of the system.
During setup, the speakers are represented by the following letters:
• L – Front left speaker
• C – Center speaker
• R – Front right speaker
• SR – Surround right speaker
• SL – Surround left speaker
• SW – Subwoofer
Channel level setting
The Auto MCACC feature (see page 26) should give you the best
surround sound setup. However you may find that by further
adjustment of the channel levels you can improve the surround
sound in your listening room.
This method of setting the channel levels allows you to listen to a
source and adjust the levels of each playback channel.
A further method of setting the channel levels is to use the test tone
method. See Adjusting the channel levels using the test tone on
page 39 for more on this.
1 Press SETUP.
2 Select ‘Sound Setup’.
Use / to select, then press ENTER.
3 Select ‘ChannelLevel’.
Use / to select, then press ENTER.
4Use / to select a channel, or use / to adjust the
level of that channel.
• You can adjust the level of each channel by ±10 dB.
5Press ENTER
once when you’re finished.
• If you use the Auto MCACC feature again, it will overwrite the
settings you have made here.
Note
• When this function is set while MCACC Effect is on, the value
for the same function adjusted with the Auto MCACC feature is
overwritten.
When MCACC Effect is off, the value set here is applied,
regardless of the value adjusted with the Auto MCACC feature.
(The Auto MCACC setting is not overwritten.)
• The range of adjustment is limited when the volume level is set
over 51.
Speaker distance setting
The Auto MCACC feature (see page 26) should give you the best
surround sound setup. However you may find that by further
adjustment of the speaker distance settings you can improve the
surround sound in your listening room.
Set the distance of each speaker from your normal listening
position.
1 Press SETUP.
2 Select ‘Sound Setup’.
Use / to select, then press ENTER.
3 Select ‘Distance’.
Use / to select, then press ENTER.
VOL
MUTE
GUIDE INFO
VOL
SYSTEM
SYSTEM
CONTROL
TV
SYSTEM
CONTROL
SYSTEM
SURR
ADV.
SURR
F.S.
SURR
SETUP
HOME
MENU
RETURN
SETUP
SETUP
TOP MENU
DISC
NAVIGATOR
HOME
MENU
TOOLS
MENU
RETURN
SETUP
TOP MENU
DISC
NAVIGATOR
HOME
MENU
TOOLS
MENU
RETURN
SETUP
TOP MENU
DISC
NAVIGATOR
HOME
MENU
TOOLS
MENU
RETURN
LX01BD_1.book Page 37 Tuesday, September 2, 2008 12:33 PM
Downloaded from www.Manualslib.com manuals search engine