Operation Manual

08
40
En
Chapter 8
Other connections
Important
• When making or changing connections on the side panel of this
unit, be sure to switch power off and disconnect the power cord
from the wall socket.
After completing all connections, connect the power cord to the
wall socket.
• Press SYSTEM CONTROL to set the remote control to receiver
control mode in order to operate the receiver subwoofer (make
sure that the LCD displays the SYSTEM screen, as shown
below).
Using this unit for TV audio
To listen to audio from a TV, connect the TV’s audio cable to one of
the inputs on this unit.
 Connect the audio output jacks on your TV to the audio
input jacks on the receiver subwoofer.
• You can connect by either a digital or analog audio cable. Select
only one method to make connections.
• To use the HDMI Control function when you are connected to a
supported Pioneer Flat Screen TV, you must connect via HDMI.
• When digital connections are used, it may be necessary to
adjust the digital audio output settings on the TV. For details,
consult the operating instructions for your TV.
Audio input settings from TVs
(TV Input)
To listen to audio from a Flat Screen TV on this device, you will need
to connect an audio cable other than an HDMI cable. From this
menu, set the audio input to that which you would like to connect.
Press TV on the remote control to switch this unit to the input
source selected here. This setting is changed to the selected input
and the audio from the Flat Screen TV is output from this device.
Select from inputs Digital 1, Digital 2 and Analog.
1 Press SETUP.
2 Select ‘System Setup’.
Use / to select, then press ENTER.
3 Select ‘TV Input’.
Use / to select, then press ENTER.
4 Adjust the setting.
Use / to adjust, then press ENTER to confirm.
VOL
MUTE
GUIDE INFO
VOL
SYSTEM
SYSTEM
CONTROL
TV
SYSTEM
CONTROL
SYSTEM
SURR
ADV.
SURR
F.S.
SURR
AM LOOP
ANTENNA
R
L
ANALOG
AUDIO IN
OPTICAL
IN 1
IN 2
DIGITAL
Receiver subwoofer
Side panel
TV
From digital audio
output (optical)
From analog audio
output
Audio cable (commercially available) can also be used for connection.
Optical cable (included)
SETUP
HOME
MENU
RETURN
SETUP
SETUP
TOP MENU
DISC
NAVIGATOR
HOME
MENU
TOOLS
MENU
RETURN
LX01BD_1.book Page 40 Tuesday, September 2, 2008 12:33 PM
Downloaded from www.Manualslib.com manuals search engine