Operation Manual
63
En
02
Caution
•When HDMI is selected for Video, no video signals are output
from the COMPONENT VIDEO, S-VIDEO or VIDEO output
terminals.
•When Component Video or S-Video/Video is selected for
Video, no video signals are output from the HDMI OUT
terminal.
• The video and audio signals output from the set output terminals
are output synchronously (lip synchronization).
• Linear PCM audio signals (2 channels) are output from all
terminals other than the ones selected for Audio, regardless of
the audio format or the player’s settings.
5 Select and set the HDMI High-Speed Transmission setting.
Use / to select On, then press ENTER.
•When HDMI High-Speed Transmission is set to Off, use the
supplied HDMI cable or a High Speed HDMI™ cable. The picture
and sound may not be output properly if any other HDMI cable
(standard HDMI™ cable) is used.
•When HDMI is selected for Video, proceed to step 8.
•When Component Video is selected for Video, proceed to
step 6.
•When S-Video/Video is selected for Video, proceed to step 7.
6 Select the output video resolution from the COMPONENT
VIDEO output terminals.
Use / to select, then press ENTER.
For details on the resolution settings, see Switching the output video
resolution on page 65.
7 Select the aspect ratio of your TV.
Use / to select, then press ENTER.
8 Check the settings.
Select Proceed, then press ENTER.
9 Output test tones.
Use / to select Yes, then press ENTER.
Caution
• The screen in step 10 and test tones are output simultaneously
according to the settings in steps 4 to 7. Lower the volume of the
devices connected with the player.
SETUP
TOP MENU
DISC
NAVIGATOR
HOME
MENU
TOOLS
MENU
RETURN
Setup Navigator
BD PLAYER
Select the HDMI Hi-speed transmission setting.
Normally select [On] (Recommended).
Select [Off] if the video or audio of HDMI-connected
was not output in the test output.
On
Off
Setup Navigator
BD PLAYER
Select the output video resolution at the
Component video terminal.
If you select [Source Direct], the output
resolution is determined according to the
video format of the playing source.
Setup Navigator
BD PLAYER
Select the screen aspect ratio to match
your TV.
Setup Navigator
BD PLAYER
Select [Proceed] if you want to start testing
your audio and video settings.
Proceed
Setup Navigator
BD PLAYER
The test tone will be output.
Reduce the volume to an appropriate level.
The video and/or audio may not be output under certain setup.
The setup menu comes back in 30 seconds.
Yes
No
LX01BD_2.book Page 63 Friday, September 5, 2008 11:29 AM
Downloaded from www.Manualslib.com manuals search engine