Projection Television User Manual

72
DIGITAL INTERFACE
POWER MANAGEMENT
This function automatically turns on power management mode if no digital
signal is input when digital signal input is selected.
When digital signal input restarts, power management mode is cancelled.
2
Select DIGITAL INTERFACE .
MENU
END
SET
SET
SELECT
SET UP
c
c
CONVERGENCE
PROGRAM BLOCK
CHANGE P AS SWORD
SYSTEM IN/OUT
CHANNEL SET UP
DIG ITAL INTERFACE
3
MENU
END
SET
SET
SELECT
DIG ITAL I NTERFACE
c
c
PICTURE SELECT: AUTO
PICTURE SETUP: AUTO
SOUND SELECT : AUTO
POWER MAN AGEMENT : O FF
PURE DIGITAL: ON
5
After setting, press MENU to turn the
menu off.
1
Press MENU and select SETUP by using
the | or \ button and then pressing «
button. (Refer to page 26.)
Select POWER MANAGEMENT .
4
MENU
END
SET
SET
SELECT
DIG ITAL I NTERFACE
c
c
PICTURE SELECT: AUTO
PICTURE SETUP: AUTO
SOUND SELECT : AUTO
POWER MAN AGEMENT : ON OFF
PURE DIGITAL: ON
Set POWER MANAGEMENT to ON.
ON ........... Turns on power management mode
OFF .......... Turns off power management mode.
NOTES:
• It can be used only during digital signal input
(INPUT 5, 6).
• When power management mode is operating, the
POWER STANDBY indicator (green) flashes.
At this time, power management mode can be shut
off to operate the monitor by pushing either the
INPUT SELECT, or MENU button on the front panel
or on the remote control. Pushing the POWER
button sets it in standby status.
STANDBY
ON
Control panel of the monitor
ARB1557A_En_068_074.P65 8/8/03, 16:5472