Projection Television User Manual

87
VARIOUS FUNCTIONS
REMOTE CODE SET UP
CABLE CONTROL BUTTONS
CABLE, SAT and DTV cannot be selected at the same time.
When the mode switch is set to CBL/SAT the cable converter
connected to the Monitor can be operated using the buttons
1 to 5.
Cable converters which are made by other makers and are
not preset can also be operated using the remote control unit
if buttons 1 to 5 have learnt the functions (see page 84).
1 Direct channel selection buttons
Press the button (or buttons) that corresponds to the
channel that you wish to watch.
2 CH (channel) +, – buttons
Press plus (+) or minus (–) to tune in a higher or lower
channel.
3
SOURCE POWER button
Turns the power of the cable converter on and off.
4 CH ENTER button *
Fix the selected channel with the direct channel selection
buttons.
5 CH RETURN (channel return) button *
Press to switch between the current channel and the
channel you were watching immediately before.
* Some manufacturers do not preset CH ENTER and CH
RETURN. Use these buttons to learn if necessary.
Mode switch
1
2
3
4
5
ARB1557A_En_081_091.P65 8/10/03, 09:3087