Projection Television User Manual

88
REMOTE CODE SET UP
SAT CONTROL BUTTONS
CABLE and SAT cannot be selected at the same time.
When SAT is preset by REMOTE CODE SET UP, the remote
control unit buttons will function as shown below.
• When a satellite broadcast tuner is connected to the
Monitor, press the input selector button that has the same
number as the connected input terminal and set the mode
switch to CBL/SAT.
The tuner can be operated using buttons 1 to 8.
• Satellite broadcast tuners which are made by other makers
and are not preset can also be operated with the remote
control unit if buttons 1 to 8 have learnt the functions
(see page 84).
1 Direct channel selection buttons
Press the button (or buttons) that corresponds to the
channel that you wish to watch.
2 CH (channel) +, – buttons
Press plus (+) or minus (–) to tune in a higher or lower
channel.
3 Select/Set buttons (SET/ENTER, |, \, », «)
|, \, », «: Press the button to select items on the SAT
GUIDE screen or MENU screen.
SET/ENTER: Press to activate the selected function.
4 SAT INFO button
When this button is pressed, information on satellite
broadcasting will be displayed.
• Use this button to learn if necessary.
5
SOURCE POWER button
Turns the power of the SAT (digital satellite system tuner)
on and off.
6 CH ENTER button
Fix the selected channel with the direct channel selection
buttons.
• Use this button to learn if necessary.
7 MENU button
When this button is pressed, the satellite broadcasting
menu screen will be displayed.
8 SAT GUIDE button
When this button is pressed, the satellite broadcasting
guide screen will be displayed.
Mode switch
2
3
5
6
7
8
1
4
ARB1557A_En_081_091.P65 8/10/03, 09:3088