Operation Manual

Other connections
08
31
En
English
1 Press SOUND .
2 Use
/ to select ‘RecMode?’ then press
ENTER .
3 Use
/ to select ‘RMode On’ or
‘RModeOff’ then press
ENTER to confirm.
• RMode On – A surround-compatible
downmix (left-total/right-total, or Lt/Rt) of
Dolby multichannel sources is output,
(suitable for Dolby Surround Pro Logic or
other matrix decoding).
•
RMode Off – A simple stereo downmix
(left-only/right-only, or Lo/Ro) is output
(suitable for playback on a two-channel
stereo system or on headphones).
Connecting external antennas
For an external AM antenna, use 5–6 meters of
vinyl-insulated wire and set up either indoors or
outdoors. Leave the loop antenna connected.
For an external FM antenna, Use a PAL
connector to hook up an external FM antenna.
Connecting the S-video output
If your TV has an S-video input, you can use this
instead of the standard video output for a
better quality picture.
• Use an S-video cable to connect the S-
VIDEO OUT
to an S-video input on your TV.
Line up the small triangle above the jack with
the same mark on the plug before plugging in.
Connecting using the
component video output
If your TV has component video inputs, you can
use these instead of the standard video output
to connect this system to your TV.
1
This should
give you the best quality picture from the three
types of video output available.
Outdoo
r
a
n
te
nn
a
5–6m
Indoor
antenna
(vinyl-coated
wire)
AM
LOOP ANTENNA
ANTENNA
PAL connector
Note
1 The component video output is switchable between interlaced and progressive formats. See Video Output settings on page 26.
FM
UNBAL 75Ω
AM
LOOP ANTENNA
OPTICAL IN
VIDEO
OUT
LINE 2
AUDIO
ANTENNA
IN
CONTROL
S-VIDEO
OUT
COMPONENT
VIDEO OUT
PR
PB
Y
VIDEO
TV
XV-DV535
S-VIDEO
INPUT
XV-DV535_IPPAN.book 31 ページ ２００５年２月２３日 水曜日 午後２時５６分