Instruction Manual

Table Of Contents

Step 1: License Plate Bar Installation

Two installation options available: the License Plate Bar can be installed on the bottom or on top of

the rear license plate. The default is installation on the bottom of the license plate. Route the cable

behind the license plate into the vehicle and connect to the system Main Unit.

Option 1. Install the License Plate Bar on the bottom of the license plate (see Fig 5).

Option 2. The License Plate Bar can also be installed at the top of the license plate if the bottom is

obstructed or does not have sufficient space for License Plate Bar installation (see Fig 6).

Note: When using Option 2, please exchange the left and right connectors of the sensor for LED

in order to get the correct signal (see Fig 7).

On certain vehicles where the license/tag plate position is higher than 4 ft (1.2 m) and not

perpendicular to the ground, please use the included wedges along with different size screws to ensure

that the bar is properly aligned perpendicular to the ground, but also secured at rear license/tag plate.

Please select the appropriate wedges behind the license plate bar to find an accurate angle as close

to perpendicular to ground as possible. Use the license plate screws to attach the appropriate wedge

for correct installation (see Fig 8 and Fig 9). This product cannot be used for front vehicle application.

CAUTION

Ensure that the connector is inserted correctly and according to the corresponding label and the

arrow marks of the wire connector at the connection point. When connecting, ensure that the KEY

or raised area of the connector mates with the opposite connector. Do not force any connection

and ensure that the connector mates properly.

To avoid any damage to the connectors, align the arrows on each of the corresponding items, then

firmly press connectors together to ensure a good connection. Failure to properly install and

connect the system components may cause damage to the product and operation of the system.

・

Fig 6

CAUTION

-12-

Fig 7

Fig 5

Option 2

R sensor

L sensor

English