Manual

FRONT PANEL FACILITIES
_99MPX MODE selector button
Use to select the auto stereo mode or monaural mode when listen-
ing to FM broadcasts. The monaural mode has been selected
when the MONO indicator is lighted.
Auto stereo mode:
Normally leave in this mode for reception. When a stereo FM
broadcast is received, it will be automatically reproduced in
stereo sound.
Monaural mode:
When receiving distant stations or stations with weak broadcast
signals, the input signal may be weak, thus resulting in increased
noise during FM stereo broadcasts. In this event, setting the
receiver to the monaural mode will reduce the noise. In this case,
however, FM stereo broadcasts will be reproduced in monaural
sound.
NOTE:
This button has no effect on reception of AM broadcasts.
1_ TUNING buttons (-, +)
+ : The FM or AM band is scanned in the direction of increasing
frequency.
- : The opposite operation to that of the UP button takes place.
1_ MEMORY button
When the unit is in the frequency display mode, pressing this but-
ton will result in the memorization of the current broadcast band,
reception frequency, and FM AUTO/MONO mode.
1_ VOLUME control
Use to adjust volume level.
1_ PHONES jack
Connect the plug on your headphones to this jack. To listen to a
program through the headphones, set both SPEAKERS A and B
switches to the OFF position.
]_ SPEAKERS ( II OFF, == ON) buttons
These are used to select the speaker through which you wish to
listen.
A: When the speakers connected to A terminals are in use.
B: When the speakers connected to B terminals are in use.
• Turn both A and B speakers to OFF position when only the
headphones are in use.
NOTE:
No sound wil/ be heard through the speakers when both A and B
buttons are pressed if on/y one set of speakers has been connect-
ed to either A or B SPEAKERS termina/s.
115_OPERATION DISPLAY panel
(a) TAPE 2 monitor indicator.
(b) MEMORY indicator
(c) S.BASS indicator
(d) MONO indicator
(e) TUNED indicator
(f) STEREO indicator
(g) Indicates the function or frequency by the function switches.
(h) Indicates channel (STATION CALL number) and sleep time.
(a) (b) (c) (d) (e) (f)
q@STATION CALL buttons
These buttons are used to preset recall desired broadcasting sta-
tions and direct access tuning.
BASS tone control
Use to adjust the low-frequency tone. The center position is the
flat(normal) posion. When tuned to the right, low-frequency
tones are emphasized.
TREBLE tone control
Use to adjust high-frequency tone. The center position is the
flat(normal) position. When tuned to the right, high-frequency
tones are emphasized.
]_ BALANCE control
Should normally be left in the center position. Adjust balance if
the sound is louder from one of the speakers. If the rights side is
louder, turn toward the L position and if the left side is louder,
turn toward the R position.
7
_ARB1470>