Manual

SETTING THE UNIT PRIOR TO OPERATION
• Before operating the unit, be sure to set it as shown below.
Set the TAPE 2 MONITOR but-
ton to OFF (TAPE 2 indicator
goes off).
Press the POWER switch to !I _]_ 1
the ON position, ii _r____ - _O O O O O
Press the SPEAKERS switch
corresponding to the speaker
system to be used.
ooo
0 0 0 0 0 0
t::_ t;:l t:;:l t::_ _1
LISTENING TO THE BROADCAST
Set the VOLUME control to
the _MIN r' position.
Set the BALANCE control to
the center position.
• Check that all terminals are properly connected before switch-
ing on the unit.
I©oo
4 3
[ ] ooooo
4
4
MANUAL/AUTO TUNING (FM/AM reception) I
1. Press the TUNER button of the function buttons.
2. Press the FM/AM selector button to select your
desired broadcasting.
3. Use the TUNING buttons to locate the frequency
of the desired station.
[Manual tuning]
Press TUNING buttons and release it quickly. The frequency will
change by one step each time the button is pressed. Press as
many times as necessary to tune in the desired station.
Steps change in the following way.
U.S. Canadian models: FM 100kHz, AM 10kHz.
Multivoltage model: FM 100/50 kHz, AM 10/9 kHz.
[Auto tuning]
Press buttons until the frequency starts to change, then release
it. The tuner will automatically search for a broadcasting station
and stop when one is found.
To search for another station, press again.
[High speed manual tuning]
Keep TUNING buttons pressed. The frequency changes continu-
ously, and stops when the button is released.
NOTE:
The TUNED indicator wil/ not function for broadcasts received
over/ong distances or when signa/s are weak.
4. Adjust the volume with the VOLUME control and
the tone with TREBLE tone control, BASS tone
control and S.BASS button.
When Receiving FM Broadcasts:
• If there is too much noise during reception of an FM stereo
broadcast, press the MPX MODE selector button to light the
MONO indicator. Switching to monaural reception results in
clear reception.
Note on Auto Tuning
• Because of high sensitivity of this unit, it may automatically
stop even at very weak overseas stations. The same can hap-
pen with aggregate radio noise emitted in cities.
• During reception of an AM broadcast, if it frequently stops
when presetting stations with auto tuning, auto tuning of only
strong local stations is possible by changing the direction of
the loop antenna or folding it down.
After presetting, move the loop antenna back to the position
where it is pointing in the best direction as before.
• Preset extremely weak stations with maunal tuning.
The TUNED Indicator
When the TUNED indicator is not lit, reception is not possible
even if the tuning frequency is correct. This is because the anten-
na terminal input is too weak. Check whether the antenna cable
is firmly connected. If it is, consult your nearest dealer and instalt
an outdoor antenna.
9
<ARB1470>