User Manual
− 17 −
English
Installation
Specified Installation Position on Front Windshield
When installing this product the inside of the front windshield, install in a vehicle and in a position that
satisfies all of the following conditions if allowed by applicable law in your location:
•Install in a 7-inch/17.8 cm square in the lower corner of the windshield farthest from the driver, a
5-inch/12.7 cm square in the lower corner of the windshield nearest to the driver and outside of any
airbag deployment zone, or in a 5-inch/12.7 cm square mounted to the center uppermost portion of
the interior of the windshield. The ideal location is behind the rearview mirror out of the driver’s view
as shown below.
•A position where this entire product is within 20% of the top edge of the height of the front windshield
(range within 20% of the actual length, excluding parts overlapping weatherstrips, mouldings, etc.
and masked parts) or are in the shadow of the rear view mirror as viewed from the driver’s seat.
Note that “20%” as described above is a rough estimate. Please install the product in accordance
with your location's laws and regulations.
•A position where the lens part of this product is within the wiping range of the wiper.
•A position where the lens part of this product does not hang over the sunshade and black ceramic
lines/black ceramic pattern.
•A position where this product faces in the horizontal direction to the front and side to side.
•A position where the cigarette lighter power cable can be routed without unnecessary force.
Installation Direction
Horizontal Direction
Main Unit
Front Windshield
Ground
Main Unit
Horizontal Direction
Main Unit
Main Unit
*Install this product in a location
where it will not interfere with the
driver’s field of view,such as behind
the rear view mirror.
Installation Angle
Allowable Installation Angle:
20° to 75° (With Lens
Horizontal)
Front Windshield
Forward Direction
of Vehicle
Within 20 % of Height
Rear View Mirror
Range of Windshield Wipers
A Pillar
A Pillar
AirBag