Manual

® @@@ @ @
/
]
FM/AM ANTENNA terminals (-._ Page 7)
Connect to FM and AM antennas.
PHONO input jacks (=1_Page 7)
Connect to the output cables from a turntable.
CD input jacks (-I_ Page 7)
Connect to the output jacks of a compact disc player.
(_ GND terminal (-I_ Page 7)
Connect the turntable ground lead to this terminal.
Loosen the screw, connect the ground lead, and then tighten the
screw.
LD input jacks (-I_ Page 8)
Connect to an LD player's output jacks (audio, video).
® REAR SPEAKERS terminals (-I_ Page 9)
Connect the rear speakers to these terminals.
Use rear speakers with impedance of 8 Q--16 Q.
® CENTER SPEAKER terminals (-I, Page 9)
Connect the center speaker to these terminals.
Use center speakers with impedance of 8 Q--16 Q.
® CENTER AMP PRE OUT jack (-I_ Page 7)
When a separate power amplifier is used to drive the surround
center speaker, connect the power amplifier to this jack.
® TAPE 2 MONITOR jacks (-_ Page 7)
Connect to audio components such as a second cassette deck or a
graphic equalizer.
VCR/TAPE 1 jacks (-I_ Pages 7, 8)
Connect to the first cassette deck or a VCR. With a VCR, also connect
the video jacks.
@ VIDEO OUT (TO MONITOR TV) jack (-I_ Page 8)
Connect to a monitor IV.
@ MULTI-ROOM REMOTE IN jack (-I, Page 10)
Connect to the separately sold MR-100 Multi-Room remote sensor
unit.
(_ CONTROL IN/OUT jacks
IN : Connect this jack to other Pioneer components (main unit or
remote control unit) when using those components to
control this unit.
OUT : Connect this jack to other Pioneer components when using
the remote control of this unit to control the other
components.
NOTE:
The receiver's remote sensor does not function when a plug is
inserted in the lNjack. To operate, point the remote control unit at the
remote sensor on the component to which the receiver's IN jack is
connected.
When using
the MR-100
/ / / co. trol
/ umt
.... Re ii_ni_:; _onea_tk ,_
_mote T:c tkhef CtOeNTROLelN
control unit component bearing
the _ mark.
(_ FRONT SPEAKERS terminals (,-_ Page 9)
A: Connect to the first set of speakers.
B: Connect to the second set of speakers.
Use speakers with impedance of 8 Q--16 2.
11
<ARB1466>