Manual

MEMORY
FM/AM k - + DIRECT ACCESS
\Xi !
/" I°° *
_-_ / _
STATION CALL
TUNER
DIRECT ACCESS TUNING
When you know the frequency of the desired station, the frequency
can be input directly using the STATION CALL (number) buttons in
the following way:
1. Select TUNER with the input selector buttons.
2. Select either FM or AM using the FM/AM button.
3. Press the DIRECT ACCESS button.
4. Input the desired station frequency using the STATION CALL
buttons.
Example: To receive FM 106.00 MHz
I
I
..
I L............ I
t5
(STATION CALL
I buttons)
:2
.. I I...i 0_ _ _.
< In the case of FM 100 kHz/AM 10 kHz step with U.S. model or Multi-
voltage model>
I I
., _l I_.LI ...
<In the case of FM 50 kHzlAM 9 kHz step with Multi-voltage
fnodel>
,. LI _ n
I
I--i i-- i--_ i--i
%
Once the station frequency has been input, the receiver tunes in that
frequency. If the input frequency falls below the lower or higher limit
of the receiver's receivable frequency range "LOWER" or "UPPER" is
displayed, indicating that the frequency which has been input
cannot be tuned in.
5. Adjust the sound volume and tone as desired.
To cancel frequency input
Direct access is canceled when the DIRECT ACCESS button is
pressed again.
Under the following conditions direct access is canceled and the
unit returns to the condition in effect before direct access was
selected:
O If there is no key input for about five seconds after the DIRECT
ACCESS button was pressed.
(_) If more than about five seconds elapse between number input.
Note regarding direct access tuning
• There is no need to input the last digit "0" of the desired station
frequency.
AUTO TUNING
Auto tuning is convenient when you do not remember the frequency
of a desired station, or when you wish to find stations that you do not
normally listen to.
1. Select either FM or AM using the FM/AM button.
2. Press TUNING "--" or "+" button until the frequency starts to
change, then release it.
eThe AUTO TUNING indicator lights, and the receiver
automatically searches for a broadcasting station, and stops
when one is found, at which time the TUNED indicator lights.
Press again to search for another station.
• To interrupt auto tuning, press TUNING button again.
3. Adjust the sound volume and tone as desired.
NOTE:
• When Auto Tuning is used, correct reception may not be possible
for very distant stations or stations with very weak signals. In this
event, Manual Tuning is recommended.
• The TUNED indicator may not fight with broadcasts received over
long distances, or when the broadcast signals are extremely weak.
15
<ARB1466>