Manual

PUllING BATTERIES INTO ]HE REMOTE

CONTROL UNIT

1. Open the battery compartment cover on the rear of the

remote control unit. The cover should open easily if you slide

it in the direction of the arrow while pressing on it with your

thumb.

2. Take out the two supplied batteries size "AA" (R6/UM-3), and

insert them into the battery compartment in accordance with

the indications in the compartment.

3. Close the cover of the battery compartment.

Incorrect use of batteries may lead to leakage or

rupture. Always be sure to follow these guidelines:

Always insert batteries into the battery compartment correctly

matching the positive (+) and negative (--) polarities, as indicated

inside the compartment.

Never mix new and used batteries.

Batteries of the same size may have different voltages, depending

on their type. Do not mix different types of batteries.

REMOTE CONTROL RANGE

• i li(_ acoessoly remote control U(llt can be used to _uk_Lr(Jl soml_

functions of other Pioneer cassette decks, CD players, tuners,

receiver, VCRs, LD players, and TVs (only those bearing the

Pioneer mark ml).

eWhen the accessory remote control unit is used to operate other

PIONEER components with the [] mark, it cannot be used to

operate functions which do not correspond to the functions listed

on the remote control unit.

Transmit mode selector switch

AUDIO:

Select this position for remote control operation of audio equipment

such as a CD player or a cassette deck.

VIDEO:

Select this Position for remote control operation of video equipment

such as an LD player, VCR or TV.

Transmit mode selector

switch

When operating the remote control unit, point thefront of the unit at

the front panel of the receiver. The remote control unit may be used

within a range of about 7 meters from the remote sensor, within

angles of up to about 30 degrees.

Performance of the remote control unit is adversely affected in the

presence of a strong fluorescent light. Keep such lights away,

especially from the sensor window.

Battery Replacement

As battery power runs down, the range over which the remote

control unit can operate decreases. When the range becomes too

short, change the batteries.