Operation Manual

Getting started04
12
En
Chapter 4:
Getting started
CAUTION
• Use of controls or adjustments or performance of
procedures other than herein expressly specified may
result in hazardous radiation exposure or other unsafe
operation.
Always follow the instructions in this chapter in sequence.
Turning on
 Press  STANDBY/ON
This product switches to the last selected source.
APS mode
• After this product is kept inactive for 15 minutes, it
automatically switches to the standby mode.
Setting the clock
Note
• During setting, if no action is made within 90 seconds, the
system exits clock setting without saving earlier
operations.
• When power supply is restored after unit is plugged in
again or after a power failure, reset the clock.
1 In the standby mode, press and hold CLOCK
to activate clock setting.
[24H] blinks.
2 Press / to select [24H] or [12H] and
then press
CLOCK to confirm.
The hour digits will blink.
3 Press / to set the hour, and then
press
CLOCK to confirm.
The minute digits blink.
4 Press / to set the minute, and then
press
CLOCK to confirm.
Selecting a source
Press INPUT repeatedly to select a source.
•[DISC]: the disc in the disc tray
•[BLUETOOTH]: Bluetooth capable device that is paired
•[USB]: .wma/.mp3 files stored on the connected USB
storage device
•[TUNER]: the FM radio
•[AUDIO IN]: the audio input through the AUDIO IN
socket
PHONES
INPUT
P.BASS
X-PM32_SYXE8_En.book 12 ページ ２０１４年７月１５日 火曜日 午後１２時１８分