User manual

Listening to the FM radio 07
19
En
English
Français Español
Chapter 7:
Listening to the FM radio
Tuning to an FM radio station
Note
• Make sure that you have connected and fully extended the
FM antenna.
1 Press FM on the remote control or INPUT
repeatedly on the main unit to switch the source
to
TUNER .
2 Press and hold
/ until the frequency
starts to change.
• To tune to a station at a specific frequency, press
/ repeatedly until the desired frequency is
displayed.
Programming radio stations
Note
• You can program up to 30 preset radio stations.
• To overwrite a programmed radio station, store another one
with its sequence number.
1 Tune to a radio station.
2 Press
PROGRAM to activate programming.
[XX] (XX indicates the sequence number) blinks.
3 Press / to allocate a sequence number
from 1 to 30 to this radio station, and then press
PROGRAM to confirm.
The preset sequence number and the frequency of this radio
station are displayed.
4 Repeat steps 1-3 to program more stations.
Tip
• Press and holding PROGRAM will allow you to freely select
any radio station. The selected station will be saved
automatically.
Tuning to a preset radio station
•Press / to select the sequence number of that preset
radio station.
Display RDS information
RDS (Radio Data System) is a service that allows FM stations
to show additional information. If you tune to an RDS radio
station, [RDS] and the station name are displayed.
1 Tune to an RDS radio station.
2 Press
DISPLAY repeatedly to scroll through
the available information:
• Station name
•Frequency
• Program type such as [NEWS] (news), [SPORT] (sport),
[POP M] (pop music)...
• Text messages
• CT (Clock Time)
X-PM32_SYXE8_En.book 19 ページ ２０１４年７月１５日 火曜日 午後１２時１８分