Operation Manual

110
Appendix NAVI/AV
*: Product Number in the Service Info Screen is not
displayed.
About the icon for the memory
navi mode
When new route guidance starts, the route data
from the map disc is read into the memory of the
navigation unit. The status of the memory navi
mode is indicated by the following icons on the
lower right of the map screen.
(green flashes): Reading the data
(green is lit): Operated in memory navi mode
(red is lit): Operated in memory navi mode,
but the distance for guidance is 20 km or less.
❒ Where the distance for navigation guidance is
unknown, the icon flashes red. In that case,
the guidance may suddenly fail. It is therefore
recommended to reinsert the map disc.
When disappears, memory navi mode is
ready. You can now remove the map disc and use
the memory navi mode function.
❒ If you want to remove the map disc while
preparing for the memory navi mode, press
the EJECT button more than 2 seconds.
When the map disc is removed, data cannot
be read and preparation for memory navi
mode will accordingly be cancelled. (Since
the reading of the map data used in the
memory navi mode is not complete, the map
scale may switch to a larger scale. In this
case, route guidance will continue up to the
location already memorised.)
In memory navi mode, you will be notified in three
cases: when the distance to the edge of the
memorised area is 20 km (12 mi), 10 km (6 mi)
and 5 km (3 mi) respectively.
Major difference between the
memory navi mode and the DVD
navi mode
• Free zooming of scale is not available.
• Detailed city map cannot be displayed.
• If a route was set to your destination in
memory navi mode, inserting the map disc
automatically starts recalculation of another
route. (You cannot cancel this reroute
operation. If the route calculation fails for
some reason, a message will appear asking
you to either recalculate a route (Reroute) or
delete the current route (Delete route). In this
case, drive for a while before touching either
“Reroute” or “Delete route” to delete the
current route, then reset the destination.)
• In some cases, you may not be able to use map
display mode during DVD navi mode. If the
map display mode is not changed during
memory navi mode, when the disc is set next
time, the display will return to the map display
mode used during the DVD navi mode.
• In memory navi mode, map scale data that
cannot be read in the memory cannot be
displayed. Accordingly, the edge of the map
will appear cut off along the point it was not
read into memory. This simply indicates the
edge of the map data, and is not a malfunction.
Route Condition
✓
Avoid Motorway
✓
Avoid Ferry
✓
Avoid Toll Road
✓
Areas to Avoid –
Settings menu
Volume
✓
System Options
"
Short-Cut Selection
✓
Map Display Options
✓
Defined Locations –
Demo Mode –
Time
✓
Modify Current Location
✓
Hardware Info
"*
Restore Factory Settings
✓
Shortcut menu
: Destination –
: Registration
✓
: Vicinity Search –
: Whole Route Overview –
: Overlay POI –
: Address Book –
: Route Options –
: Edit Current Route –
: Traffic On Route –
Main menu
MAN-CNDV-50MT-EN.book Page 110 Wednesday, May 4, 2005 1:49 PM