Operation Manual

Additional information
27
En
Factory reset, clearing all memory
CAUTION
• If iPod/iPhone/iPad mini is connected to the unit,
disconnect it.
Important
• Perform the following operations for the
stereo receiver
and CD player separately to reset both of the
stereo
receiver and CD player.
1 Turn on the unit.
Refer to To turn the power on on page 13 for details.
2 Select the stereo receiver or CD player by pressing the
CONTROL RCV or CONTROL CD button on the remote
control.
3 Press the SETUP button.
4Press the
/ button to select 'Factory Reset'.
5 Press the ENTER button.
6Press the
/ button to select 'RESET OK?'.
7 Press the ENTER button.
The stereo receiver or CD player is restarted automatically.
CAUTION
• This operation will erase all data stored in memory
including clock, timer settings, tuner preset, and CD
program.
Before transporting the unit
Remove the iPod/iPhone/iPad mini, USB memory device and
disc from the unit. Then, set the unit to the power stand-by
mode. Carrying the unit with iPod/iPhone/iPad mini or USB
memory device left docked or discs left inside might damage
the unit.
Care of compact discs
Compact discs are fairly resistant to damage, however
mistracking can occur due to an accumulation of dirt on the
disc surface. Follow the guidelines below for maximum
enjoyment from your CD collection and player.
• Do not write on either side of the disc, particularly the
non-label side from which signals are read. Do not mark
this surface.
• Keep your discs away from direct sunlight, heat, and
excessive moisture.
• Always hold the CDs by the edges. Fingerprints, dirt, or
water on the CDs can cause noise or mistracking. If a CD
is dirty or does not play properly, clean it with a soft, dry
cloth, wiping straight out from the centre, along the
radius.
Cleaning the cabinet
Periodically wipe the cabinet with a soft cloth and a diluted
soap solution, then with a dry cloth.
CAUTION
• Do not use chemicals for cleaning (petrol, paint thinner,
etc.). It may damage the cabinet.
• Do not apply oil to the inside of the unit. It may cause
malfunctions.
Caution for when the unit is installed in a rack
with a glass door
Do not press the  OPEN/CLOSE on the remote control to
open the disc tray while the glass door is closed. The door will
hamper the movement of the disc tray, and the unit could be
damaged.
YES
Correct
NO