Instruction Manual

Controls and Displays02
12
En
1 CHANNEL INDICATORS
Light to indicate the selected channel.
2 CHANNEL
In case of poor reception due to interference
from other electrical devices, you can improve
reception by selecting another channel. Each
time you press the button, the channel
changes sequentially:
• Poor reception may cause the audio to be
interrupted or stopped. This is not
malfunction. Try changing the location or
orientation of the transmitter and/or the
wireless speaker to improve reception.
• The wireless speaker can be used at
distances of up to 10m from the
transmitter. This range may change
depending on the environment.
3 Transmitter antenna
Transmits signals to the wireless speaker.
4 Wireless speaker antenna
Receives signals from the transmitter.
5POWER
Press to switch the unit on or off.
6 WIRELESS MODE switch
Slide to either select
W.SURROUND or
W.STEREO mode.
W.SURROUND - Sounds going to the
surround left and right channels are heard
through the wireless speakers.
W.STEREO - The wireless speaker can be
used as a second stereo speaker system
(which will output the same stereo signal as
the main system) when you use this setting
with the 5-STEREO mode on the receiver. You
will be able to adjust the sound of this speaker
independently using the
STEREO MODE
VOLUME
control (see below).
• When set to
W.SURROUND, the
STEREO MODE VOLUME control does
not function.
7 STEREO MODE VOLUME
Turn to adjust the speaker volume when the
WIRELESS MODE is set to W.STEREO.
The
STEREO MODE VOLUME control has
no effect when set to W.SURROUND. Use the
receiver volume control to adjust the speaker
volume.
8POWER indicator
Lights when the wireless speaker is switched
on.
9TUNED indicator
Lights when the signal from the transmitter is
properly received.
10 AUDIO LEVEL
Turn to adjust the wireless speaker volume.
Changing the volume with
W.SURROUND
When W.SURROUND is selected, you can
control the level of the wireless speaker by
adjusting the LS and RS channel levels as
necessary for balanced surround sound.
[VSX-C402] Refer to the section on Setting
individual channel level in the receiver’s oper-
ating instructions.
[VSX-D514] Refer to the section on Setting
the relative volume level of each channel in the
receiver’s operating instructions.
[VSX-D514 only]
You can also use the signal converter AUDIO
LEVEL control to adjust the wireless speaker
volume.
• When setting up the receiver, make sure
the surround speakers are set to S(small).
Settings larger than S will result in lower
frequency distortion in sources that have
a lot of bass.
CH 2 CH 3 CH 4
CH 1
EN_XW-HTD525.book Page 12 Tuesday, April 27, 2004 7:14 PM