User manual

2. Confi rm your unit’s fi rmware version.
Confi rm the unit’s fi rmware version on the Web Control menu.
If the four digits following the “S” are lower than [1050], a
fi rmware update is required. If the four digits are same or
greater than [1050], no update is required.
S1000.1000.0
XW-SMA1
S1050.1000.0
3. Download the new fi rmware.
The fi rmware update can be downloaded from Pioneer’s
website.
Note
• The fi rmware fi le will be downloaded to the folder you specify.
• Depending on your browser and its settings, the destination
selection window may not appear when downloading
the fi rmware fi le. In this case, the fi le will be downloaded
automatically to the folder designated in your browser settings.
• The fi rmware fi le will be downloaded in compressed “zip”
format.
(Example) Compressed fi le name: SMA2013NMP****.zip
The four asterisks (****) indicate the version number.
4. Open the downloaded compressed fi le.
Decompress the fi rmware fi le and store the contents in a folder
of your choosing.
Note
• When the compressed fi le is decompressed, a new folder will
be created and the updated fi rmware fi le (SMA2013NMP****.fw)
will be stored in the new folder.
• For more information about how to decompress fi les, consult
your software or computer dealer.
Listening to Pandora/Internet Radio
If using ControlApp for the fi rst time, follow these procedures to start the application.
5. Select fi rmware update.
On the Web Control menu, click on Firmware Update (a)
followed by Start (b).
a
b
The Firmware Update Prepare screen is displayed. If the
screen does not switch automatically, click on Click Here.
6. Select the update fi le.
Click on the Choose File button (a) and select the fi rmware fi le
(SMA2013NMP****.fw) previously downloaded, and then click
on the Upload button (b). Then, press Yes on the confi rmation
screen. Once the update has begun, it cannot be cancelled.
b
a
S1000
BCO_1000.fw
11
7. Confi rm that the update has completed properly.
When the update has begun, the update process will be
displayed. When the update process fi nishes, follow the
instructions on the screen and unplug the power cord.
Note
• If the update process is not completed within ten minutes, try
unplugging the unit, then repeat the update process.
Installing ControlApp
Next, the Pioneer application ControlApp must be installed on your mobile device. For more information about your operating environment,
access the appropriate Website as noted below.
If using an iPhone or iPod touch
For iPhone or iOS device, you can obtain from “AppStore”.
1. Connect this unit to the network you normally use.
2. Connect your mobile device to the same network.
Confi rm that ControlApp is installed on your mobile device.
3. Turn on the power to this unit.
4. Start ControlApp on your mobile device.
on
input
network
input
volume
standby/on
Wired/Wireless
Wireless
5. Tap the Download button.
When download is completed, the CONTROL screen will be
displayed.
Download
2
If using an Android device
For Android, you can obtain from “Google Play”.