Operation Manual

Connect to network 04
19
En
A: Connections for wireless LAN using WPS-
PBC function
1 Confirm that the AC adapter and LAN cable
are not connected to the unit.
2 Connect the AC adapter, and press
 standby/on button.
The on indicator will flash blue. Wait for about 30 to 40
seconds.
3 When the on indicator stops flashing, press
the rear-panel network setup/wireless direct
button.
The network indicator will change from flashing red to
flashing purple.
4 Within 2 minutes, press the router’s WPS
button.
For information regarding router operation, consult the
router’s Operating Instructions.
5 The network connection settings will be
performed automatically, and when the
connection is complete, the unit's indicator will
briefly change to flashing red, then light steadily
blue.
The indicator will flash blue when the signal is weak.
B: Wired connection to a router with DHCP
server
1 Disconnect the power cord from AC power
before performing the connection between
router and this unit.
Use a LAN cable to connect this unit and your router.
2 Connect the AC adapter, and press
 standby/on button.
The on indicator will flash blue. Wait for about 30 to 40
seconds.
3The on indicator's flashing will stop, and
when the power is fully turned on, the network
indicator will light blue.
AUX INDC INiPod/iPhone/iPadLAN(10/100)
AUX INDC IN
input
volume
standby/on
6
on
input
network
network setup
wireless direct
AUX INDC IN
WPS
WPS
on
input
network
blue
AUX INDC INiPod/iPhone/iPadLAN(10/100)
WAN
321
LAN
AUX INDC IN
input
volume
standby/on
6
on
input
network
blue