Instructions

3B-1 3B-2
3B-3 3B-4
25/64 in.(10mm)
Concrete Drill
ø10mm
70mm
A2
A3
A1
WARNING:
● Mount the wall plate [01] directly onto the concrete surface
● Minimum solid concrete thickness: 203 mm (8 in.)
● Minimum concrete block size: 203 x 203 x 406 mm (8 x 8 x 16 in.)
Position the wall plate at your desired
height, level the wall plate and mark the 4
pilot hole locations.
Drill 4 pilot holes
using a 25/64
in.(10mm) diameter
drill bit.Make sure the
depth is not less than
23/4 in.(70mm).
Install wall plate using lag bolts A1, washers A2
and anchors A3. Be sure the anchors [A3] are
seated flush with the concrete surface. Tighten
the lag bolts [A1] only until the washers [A2] are
pulled firmly against the wall plate[01] . DO
NOT over-tighten the lag bolts [A1].
Use the hammer to knock
anchors A3 into the wall.
6