Manual

PMI Piranha
™
15
MAINTENANCE OF THE PMI PIRANHA™
The PMI Piranha™ is easy to strip for cleaning and basic maintenance. Regular cleaning and mainte-
nance is highly recommended, including frequent checks of all power system com-
ponents. Keep screws tightened. Replace worn components with factory parts; all leaks must be repaired prompt-
ly. Power system repairs are best performed by the factory or an authorized factory repair facility; contact PMI for
information regarding authorized PMI Piranha™ repair facilities.
WARNING
DO NOT ATTEMPT TO PERFORM MAINTENANCE PROCEDURES UNLESS QUALIFIED TO DO SO. DO NOT DISASSEMBLE
MARKER UNTIL IT IS COMPLETELY DRAINED OF COMPRESSED GAS OR AIR AND ALL PAINTBALLS HAVE BEEN REMOVED.
ALL FILLING OF COMPRESSED GAS OR AIR CYLINDERS MUST BE DONE BY QUALIFIED PERSONS.
CONTACT PMI, INC., FOR REPAIR ASSISTANCE AND INFORMATION REGARDING AUTHORIZED PMI PIRANHA™
REPAIR FACILITIES.
PAINTBALL MARKER POWER SYSTEMS MUST BE REPAIRED OR REPLACED ONLY WITH THE CORRECT
PRESSURE RATED COMPONENTS.
DISASSEMBLY PROCEDURE
1. Before disassembly of the marker, remove all paintballs from the marker, barrel, and loader; remove power source;
and remove all gas or air from the power system.
2. Leave barrel plug firmly inserted in barrel and keep
barrel pointed in a safe direction.
3. To remove the bolt/hammer assembly, first remove the
field strip pin. Figure 10 The field strip pin is at the
upper rear of the receiver and is removed by pulling it
out of the left side of the marker.
Figure 10 Remove field strip pin to begin disassembly.