Manual

4. To remove the ASA adapter, remove the small allen screw under the receiver. Figure 30. The ASA adapter
can then be removed. Figure 31. NOTE: The o-ring on the ASA adapter that, at insertion, contacts the
receiver first is white. The
other o-ring is black.
5. To access the valve assembly, remove the the valve spring, pin, and guide as in Figure 32. Remove the
small brass screw located in the center of the underside of the receiver, Figure 33. To remove the valve
body, use a flat ended wooden dowel to push the valve body out of the front the receiver, Figure 34.
The valve body must be inserted correctly: note that the hole to the rear of the valve is tapered, and has
a black o-ring. The front of the valve is not tapered and has a white urethane o-ring. The valve pin
assembly must be inserted correctly; valve pin must drop down into valve body completely. Valve spring
must be centered in valve bore.
6. Follow the procedures in this manual for adding power system, loader, and paintballs.
Questions about the operation of the PMI Piranha™ paintball marker may be directed to: Pursuit
Marketing, Inc., 5035 River Road, Schiller Park, IL 60176 USA ; phone [phone] ext. 7150 www.pminet-
work.com
Figure 32
Figure 33
Figure 34
Figure 30
Figure 31
PMI Piranha
™
20