Manual

PMI Piranha
™
22
TRIGGER AND SHOOTING
Trigger will not pull back Check that mechanical safety is not engaged; safety should
be fully pushed toward left side of marker and red o-ring
on safety should be fully visible
Trigger pulls back, marker will not shoot Check that marker is cocked, air source is correctly
attached, and air source is adequately filled
Trigger action does not feel smooth Check pin at top of trigger near trigger frame; if it catch
es on the edge of the frame, use center punch to tap pin
back into place
Marker runs on (partially cycles more than Check that air source is correctly attached and air source
is once when trigger is squeezed) adequately filled. Check
sear for wear. Check hammer o-ring
for wear and replace hammer o-ring if needed, using fac-
tory o-ring only. Use of other than factory o-ring can
cause run on.
VELOCITY
Low Adjust using velocity adjuster
Low Check that air source is adequately filled
Low Remove bolt/hammer assembly and clean it; clean inside
receiver area where bolt/hammer assembly is located
Low Change to a stiffer hammer spring
High Adjust using velocity adjuster
High Change to a less stiff hammer spring
CHRONOGRAPH THE MARKER AT REGULAR INTERVALS DURING THE DAY, AS WELL AS ANY TIME THE POWER
SOURCE IS REFILLED OR CHANGED, ANY TIME THE BARREL OR ANY PART IN THE POWER SYSTEM IS CHANGED,
AND UPON REQUEST OF ANY PLAYER OR GAME OFFICIAL.
DO NOT EXCEED 300 FPS VELOCITY.