Manual

PAINTBALLS
Not flying straight Check for broken paint in barrel, loader, feed tube, cham-
ber, and bolt/hammer assembly area. Disassemble and
clean.
Break in barrel Check ball retainer (RP 1160) and replace if necessary
Do not drop into feed tube Shake loader; check loader and feed tube for broken paint
Two shoot at a time Check ball retainer (RP 1160) and replace if necessary
SHOOT ONLY QUALITY PAINTBALLS. PMI PREMIUM, PMI GOLD TWO-TONE™, AND
MARBALLIZER™ PAINTBALLS ARE RECOMMENDED FOR USE IN THE PMI PIRANHA™
BARREL
Barrel comes loose Check barrel o-ring; firmly tighten barrel
Aftermarket barrel does not tighten Check to see that the threads on the barrel match
or is difficult to tighten the threads on the receiver; if
threading is mismatched, barrel is not designed for use
with PMI Piranha™
PMI Piranha
™
23
TROUBLESHOOTING
WARNING
DO NOT ATTEMPT TO PERFORM MAINTENANCE PROCEDURES UNLESS QUALIFIED TO DO SO.
CONTACT PMI, INC., FOR REPAIR ASSISTANCE AND INFORMATION REGARDING AUTHORIZED PMI PIRANHA™
REPAIR FACILITIES.
BEFORE DISASSEMBLY OF THE MARKER, REMOVE ALL PAINTBALLS FROM THE MARKER, BARREL, AND LOADER; REMOVE
POWER SOURCE; AND REMOVE ALL GAS OR AIR FROM THE POWER SYSTEM.
PAINTBALL MARKER POWER SYSTEMS MUST BE REPAIRED OR REPLACED WITH THE CORRECT PRESSURE
RATED COMPONENTS.