Manual

WARNING
Every person within range of an area where a paintball marker is in use must wear protective goggles and headgear
specifically designed for paintball.
1. Attach threaded barrel firmly to marker.
2. At this time, do not attach power source or loader and do not load paintballs into marker.
3. Insert barrel plug firmly into barrel.
4. Pull the cocking knob straight back from the rear of the marker until the cocking
mechanism locks back in the cocked position. Figures 1 and 2.
5. Squeeze the trigger with an even pressure. The cocking knob will snap forward
into the uncocked position.
6. Attach feed tube elbow and empty loader. If the feed tube elbow is difficult to
attach, run hot water over the elbow or soak it in hot water for a minute,
which will help the elbow expand for easier attachment.When the elbow cools, the
snug fit will help the loader remain in position.
7. Cock the marker.
WARNING
The power system contains compressed gas or air when pressurized. Never disassemble marker until removing all gas
or air from the power system. Rules for safe handling of compressed gas or air must be followed at all times .
PMI Piranha
™
4
O P E RATING THE PMI PIRANHA™ PAINTBALL MARKER
Figure 1 Pull Back
Figure 2 Fully Cocked