User Manual

USER MANUAL

Peplink Balance Series

To reorder a rule’s position, just drag on the rule by holding the left mouse button, move it to the desired

position and drop it by releasing the mouse button.

To remove a rule, click

Rules are matched from top to the bottom. If a connection matches any one of the upper rules, the

matching process will stop. If none of the rules is matching, the Default rule will be applied.

By default, the Default rule is Allow for both outbound and inbound accesses.

Tip

If the default inbound rule is set as Allow for NAT enabled WANs, no inbound Allow firewall rules will be required

for inbound Port Forwarding and inbound NAT Mapping rules. However, if the default inbound rule is set as

Deny, a corresponding Allow firewall rules will be required.