User's Manual

http://www.pepwave.com

New Custom Rule Settings

Service Name

This setting specifies the name of the custom rule.

Enable

This setting specifies whether the outbound traffic rule takes effect.

With an Enable value of Yes, the rule takes effect: traffic is matched, and actions are

taken, by Pepwave MAX based on the other parameters of the rule.

With an Enable value of No, the rule does not take effect Pepwave MAX disregards the

other parameters of the rule.

Source

This setting specifies the source IP Address, IP Network or MAC Address for outbound

traffic that matches the rule.

Destination

This setting specifies the destination IP Address or IP Network or Domain Name for traffic

that matches the rule.

Domain Name

If Domain Name is chosen and a domain name, such as foobar.com, is entered, any

outgoing accesses to foobar.com and *.foobar.com will match this criterion. You may

enter a wildcard (.*) at the end of a domain name to match any host with a name having

the domain name in the middle. If you enter .*, for example, then www.foobar.com,

www.foobar.co.jp, or foobar.co.uk will also match. Placing wildcards in any other position

is not supported.

NOTE: if a server has one Internet IP address and multiple server names, and if one of the

names is defined here, then accesses to any one of the server names will also match this

rule.

Protocol and Port

This setting specifies the IP Protocol and Port of outbound traffic that matches this rule.

You may select some common protocol from the Protocol Selection Tool drop-down

menu.