User's Manual

Pepwave MAX and Surf User Manual

http://www.pepwave.com 154 Copyright @ 2016 Pepwave

Email Notification Settings

Notification

This setting specifies whether or not to enable email notification. If Enable is checked, the

Pepwave router will send email messages to system administrators when the WAN status

changes or when new firmware is available. If Enable is not checked, email notification is

disabled and the Pepwave router will not send email messages.

SMTP Server

This setting specifies the SMTP server to be used for sending email. If the server requires

authentication, check Require authentication.

SSL Encryption

Check the box to enable SMTPS. When the box is checked, SMTP Port will be changed to

465 automatically.

SMTP Port

This field is for specifying the SMTP port number. By default, this is set to 25; when SSL

Encryption is checked, the default port number will be set to 465. You may customize the

port number by editing this field. Click Default to restore the number to its default setting.

SMTP User

Name /

Password

This setting specifies the SMTP username and password while sending email. These

options are shown only if Require authentication is checked in the SMTP Server setting.

Confirm SMTP

Password

This field allows you to verify and confirm the new administrator password.

Sender’s Email

Address

This setting specifies the email address the Pepwave router will use to send reports.

Recipient’s

Email Address

This setting specifies the email address(es) to which the Pepwave router will send email

notifications. For multiple recipients, separate each email addresses using the enter key.

After you have finished setting up email notifications, you can click the Test Email

Notification button to test the settings before saving. After Test Email Notification is