User's Manual

User Manual
http://www.pepwave.com
71
Copyright © 3/27/14 Pepwave
12. Restoring Factory Defaults
The following procedure restores the settings of your Pepwave to factory defaults:
Power on the unit and wait for one minute.
Press and hold the reset button for at least five seconds, then release.
The unit will automatically reboot.
Wait for one minute or until the Status LED turns green, upon which the settings of the
device will have been restored to the factory defaults.
By default, the unit will acquire an IP address from a DHCP server.
12.1 AP One
12.2 AP One 300M