User's Manual

Pepwave MAX and Surf User Manual

http://www.pepwave.com

134

Navigating to AP>Settings on some Pepwave models displays a screen similar to the

one shown below:

Wi-Fi Radio Settings

Operating

Country

This option sets the country whose regulations the Pepwave router follows.

Wi-Fi Antenna

Choose from the router's internal or optional external antennas, if so equipped.

Important Note

Per FCC regulations, the country selection is not available on all models marketed in

the US. All US models are fixed to US channels only.

Wi-Fi AP Settings

Protocol

This option allows you to specify whether 802.11b and/or 802.11g client association

requests will be accepted. Available options are 802.11ng and 802.11na. By default,

802.11ng is selected.

Channel

This option allows you to select which 802.11 RF channel will be used. Channel 1

(2.412 GHz) is selected by default.

Channel Width

Auto (20/40 MHz) and 20 MHz are available. The default setting is Auto (20/40 MHz),

which allows both widths to be used simultaneously.

Output Power

This option is for specifying the transmission output power for the Wi-Fi AP. There are 4

relative power levels available – Max, High, Mid, and Low. The actual output power

will be bound by the regulatory limits of the selected country.

Beacon Rate

This option is for setting the transmit bit rate for sending a beacon. By default, 1Mbps is